LEXMARK FORMS PRINTER 2400 SERIES DRIVER

Whenever parts are replaced, make sure that all adjustments are correct by running diagnostics procedures and checking adjustments as needed. Covers 24xx Assembly 1: Page 95 24xx 5. Turn the print unit upside down. Printer will not print, or become ready.

Uploader: Kerisar
Date Added: 9 August 2013
File Size: 32.50 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 49563
Price: Free* [*Free Regsitration Required]

Abnormal Indications Symptom Action 7 or more lights turn Disconnect the interface cable from the printer and on but do not turn turn the printer off and then on.

Remove the options cover [A], by pulling it outward, up and out of xeries printer. Once reported, our staff will be notified and the comment will be reviewed.

Special tools and test equipment are listed in this chapter, as well as general environmental and safety instructions.

Turn the print unit upside down.

Lexmark Forms Printer 2400 Service Manual

Printhead-to-Platen Gap Adjustment Perform the printhead-to-platen gap adjustment after replacing the carrier, platen, lower pinch roller, ribbon drive rack gear, lexmark forms printer 2400 series side frame, right side frame, paper separator, lower feed roller, or paper guide. Following these recommendations can help prevent problems and maintain optimum performance. Lubrication Points grease 24xx Lubrication Points Grease Gear mounting studs on the right side frame [2].

See Also  WUP-028 DRIVERS

Got it, continue to print.

Remove the 4 small screws securing the paper select sensor to the left side frame. Make sure paper and the ribbon cartridge are installed. Remove the lower carrier motor mount screw [A].

Lexmark Forms Printer 2400 Series

Data options Defines how information is processed. Use only mineral oil-based lubricants.

The paper should not park or load when the pull tractor actuator is held down. Remove the two platen screws [A] prniter each end of the platen. Error Indication Table 24xx Error Indication Table The following table describes the service check entries for the printer error indication codes.

Lexmark and series, , , , dot matrix Printer Repair Parts

They are especially well-suited for applications that use continuous or multipart forms. Run the print test do not fold or damage the cables during the test. Covers, Removals Repair Information Perform the appropriate action before you go to the indicated service check. Form feed length is not correct. Page 95 24xx 5. Page 97 24xx 4. Check the following in the order listed and if the printer does not foms lexmark forms printer 2400 series, go to the indicated service check.

See Also  LEXMARK 332N DRIVERS FOR MAC DOWNLOAD

Loosen the carrier belt: Thank You for Submitting Your Review,! Page 69 24xx lexmark forms printer 2400 series. Diagnostic Information Start Make a quick visual check for defects loose or broken parts, unplugged rorms, paper jams, and so on.

Remove the screw [A] securing the carrier motor forjs to the bottom cover. Note that your submission may not appear immediately on our site. Print Test 24xx Print Test The print test helps you test and troubleshoot the printer.

Lexmark Forms Printer Series | eBay

Disconnect the home position sensor cable from the logic board. The and are wide-carriage versions of the and If this indication occurs, the problem may be with the paper present sensor or the paper select sensor.

Disconnect all cables from the logic board, except the power supply cable.