TTP-245 DRIVER FOR WINDOWS

Got it, continue to print. Place the printer on a flat, secure surface. To calibrate gap or black mark sensor, depends on the sensor setting in the last print job. Open the printer top cover by releasing the top cover open levers. Black Mark Sensor Calibration 4.

Uploader: Aranris
Date Added: 24 May 2016
File Size: 54.74 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 68099
Price: Free* [*Free Regsitration Required]

Dump Mode Ttp-245 mode Ttp-245 will enter dump mode after printing printer configuration. Dump mode Printer will enter dump mode ttp-245 printing printer configuration.

When facing the front of the ttp-245 pull the cover release levers on both sides of printer towards you. Introduction This printer provides both thermal transfer and ttp-245 thermal printing at user selectable speed of: To print the manual completely, please, download it.

Push down on the ribbon access window to unlatch and open the cover. Feed the paper, printing ttp-245 facing up, through the ttp-245 guide and pass over the platen. Close the top cover by arranging the top cover support back to the flute and ttp-45 it forward then ttp-245 the cover slowly.

See Also  ATI HD4650 DRIVERS DOWNLOAD

Always turn off the printer before cleaning the print Printer Head head. Comments to this Ttp-245 Your Name. Table Of Ttp-245 Contents Install a paper roll on the paper roll mount.

Feed the paper, printing ttp-245 face up, through the paper guide and pass over the ttp-245. Print head check pattern Firmware version Firmware checksum Printed ttp-245 meter Serial port configuration This manual also for: Remove two screws at the hinge and remove one screw at ttp-245 card cover. Please follow the steps as below.

Place a roll of paper onto the center of the paper roll mount. Connect the printer to the computer ttp-245 the Ttp-245 or USB cable. Table of Contents Add to my manuals Add.

TSC TTPC – EMS Barcode Solutions

The utilities are listed as below: Page 10 Please ttp-245 the steps below to install the ribbon into printer. Make sure the power switch is ttp-245. Copyright Declaration Information in this subject to change without notice and does not represent a ttp-245 on the part ttp-24 Taiwan Semiconductor Company.

See Also  FW82801FB DRIVERS FOR MAC

ttp-245 Got it, continue to print. Upside down the printer.

TSC TTP Plus Barcode Printer

Peel-off panel Roller Fig. Arrange the lower inner cover back to the lower cover. Ttp-245 pressing ‘print’ button you will print only current page. The top cover ttp-245 will hold the printer top ttp-245. Page 3 Update History Any amber will do during the 5 blinks.

ttl-245

TSC TTP-245 Barcode Printer

Amber Ttp-245 illuminates that the system is clearing data from printer. Print Width mm ttp-245 Max. Power On Utilities 4. Pull the label outward tightly after closing the top cover.

Open the peel-off panel by pulling it out.